FAQ about e-cigarettes

 

The LED light on the button flashes (Equipment used as an example: Vape Pen 22):

  • The heater is defective (go to the nearest Vapista showroom and we will exchange the defective heater) 
  • 8-second protection. The LED light flashes 5 times if you hold the button down longer than 8 seconds. In such a case the battery ceases to forward power to the vaporizer. 
  • Resistance protection. If the resistance of the vaporizer’s heater is lower than 
  • 0.1 ohm or higher than 2.5 ohms, then the LED light will flash 4 times and the battery will switch itself off automatically. 
  • Low voltage (V) protection. If the battery’s voltage drops below 3.3V then the LED light flashes 15 times and the battery ceases to send power to the vaporizer. 
  • The equipment is defective if the LED light does the following: 
    1.The LED does not stop blinking 
    2.The LED does not switch off


Tips to solve the problem:

  • Try using a heater with a resistance of 0.1-2.5 ohm. If the heater has resistance in the range of 0.1-2.5 ohm and the equipment still does not function, then the cause might be a defective or old heater. 
  • If the equipment does not become functional, contact our client services. Our client services can be contacted by e-mail: contact@vapista.com.au

 

The device says “Atomizer short”:

  • Check that the vaporizer’s heater has a resistance greater than 0.1 ohms.
  • Remove the vaporizer from the equipment and check that the heater is correctly attached to the base of the vaporizer. 
  • If possible, exchange the old heater with a new one. 
  • If you have the possibility, then try attaching another vaporizer to the equipment.
  • If other vaporizers function with the equipment, then the vaporizer or heater must be defective. 
  • If the other vaporizers or heaters do not function, we recommend contacting our client services. Our client services can be contacted by e-mail: contact@vapista.com.au

 

The device says “No coil” or “No atomizer”:

Possible causes:

  • A poor connection between the vaporizer and the device. Remove the vaporizer from the equipment and clean the equipment’s 510 threaded connection. Clean the vaporizer’s connection point too. 
  • The heater does not connect or is broken. Open the vaporizer and check that the heater is properly attached to the vaporizer’s base. There is also the possibility that the heater has a defect or is old and the wire inside is broken. 
  • If neither of the previous variables didn't resolve the issue, then the 510 threading may be defective, and we recommend contacting our client services. Our client services can be contacted by e-mail: contact@vapista.com.au

 

The device says “Ohms too low” or “Ohms too high”:

Possible causes:

  • The device does not have a proper connection with the vaporizer. Check that the vaporizer has been placed together correctly as well as correctly attached to the device (!! but it should be remembered that when screwing the vaporizer onto the device, excessive power is not needed nor recommended!!)
  • Check that the heater is correctly screwed onto the vaporizer’s base. If it is, try using another heater. 
  • There is the possibility that the 510 connection is damaged or defective in which case we recommend contacting our client services. Our client services can be contacted by e-mail: contact@vapista.com.au

 

The device’s screen does not function:

Possible causes:

  • The device is in “stealth mode”. In the given mode the device’s screen is switched off while vaping. Changing modes is explained in the user manual or by contacting our client services. 
  • The device is defective. Please contact our client services. Our client services can be contacted by e-mail: contact@vapista.com.au

 

About e-cigarettes:

  • The e-cigarette or electronic cigarette reduces damages and is a superb aid in quitting smoking. You will certainly find a good e-cigarette from our web store to finally quit smoking! Below we present three starter packages that we would show you in our showrooms. The equipment makes quitting smoking simple and efficient. Should you have further questions are sure to contact us. You may also read more about e-cigarettes here: What is an e-cigarette?

  • The heater is the component of the e-cigarette which vaporizes the liquid. The heater needs to be exchanged as over time it collects dirt and the taste becomes unpleasant. The heaters presented here are suitable for the above e-cigarettes. Contact us if you have any hesitancies about the suitability of the heater! 

  • The e-liquid consists of only a few components: propylene glycol, vegetable glycerine, and flavorings. The e-liquid is heated with the heater until boiling which creates steam which can be breathed in. There is a broad range of flavors for e-liquids, with or without nicotine. 
     
  • The vaporizer is the “tank” for the liquid, consisting of the e-liquid and heater. Our web store offers different vaporizers in case you want to build your own e-cigarette using a vaporizer and separate devices or MODs. Here are three vaporizers which are well suited to those wanting to quit smoking. 

  • E-cigarette devices or MODs. The task of the device is to give the vaporizer power so that the heater gets hot. There are very different devices. Currently, devices are almost always with screens, which contain electronics that give the vaporizer the exact power you have chosen. Below there are three devices which are well suited to the above vaporizers. The devices come with built-in batteries as well as with exchangeable batteries.